Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFAAC Gate Access Control in Little Elm: What to Know First
We provide independent FAAC gate access control service in Little Elm, from keypad entry and remote programming to full phone-entry and video-intercom integration. Most FAAC access-control repairs are completed in one visit, and we quote the price before any work begins so there are no surprises on the bill. If you’re a Little Elm homeowner with a FAAC gate that won’t respond to a remote, a keypad that’s gone dark, or an intercom that stopped ringing the house phone, this page tells you exactly what you’re dealing with. Call (432) 547-6481 and a live person answers, 24 hours a day, 7 days a week.
How FAAC Products Fail - and How We Fix Them
FAAC equipment is well built, but every brand has its weak points. Here are the failure patterns we see most often on FAAC gates in Little Elm, and what we do about them.
- FAAC 412 and 415 operator boards losing their memory. These are the most common FAAC operators on Little Elm driveways, and the control board is usually the first thing to go. A power surge or a lightning strike near the gate will often scramble the board’s programming, so the gate forgets its remotes and keypad codes entirely. The symptom is simple: the gate still has power, but nothing responds. We re-flash the board when it’s recoverable, and when it isn’t, we install a replacement board and reprogram every remote, keypad, and safety input on the spot.
- FAAC keypads going dark after a hard rain. Little Elm gets serious spring and fall storms, and water intrusion into the keypad housing is a recurring problem. The FAAC keypad uses a ribbon-style connector that corrodes when moisture seeps past the faceplate gasket. The fix is not to spray contact cleaner and hope. We open the housing, replace the corroded connector, reseal the gasket with fresh silicone, and test the keypad through twenty cycles before we leave.
- Photo-eye wiring getting chewed by Texas heat and critters. FAAC’s safety photo-eye circuit runs through low-voltage wiring along the gate track or the fence line. In Little Elm, the combination of sun-baked conduit and squirrels or rabbits chewing through the insulation causes intermittent faults where the gate reverses for no visible reason. We trace the wire, find the actual break or chew point, and splice it in a weatherproof junction box instead of wrapping it in tape and calling it done.
- FAAC phone-entry systems not ringing the house. Many Little Elm homes with FAAC gates have a landline-style phone entry unit wired to the house phone. When the homeowner drops their traditional landline and switches to VoIP or a cellular home phone, the FAAC entry unit can no longer complete the call. The gate still opens with remotes, but visitors at the keypad hear nothing. We reconfigure the entry unit for the new phone service or install a compatible cellular gateway so the gate still rings the house.
- Remote controls that work only from ten feet away. FAAC remotes use a fixed-code or rolling-code signal depending on the receiver year. When the antenna wire inside the operator housing gets bent, pinched, or corroded, the receiver range collapses. A homeowner will stand next to the gate and it works fine, but from the car at the end of the driveway, nothing. We replace the antenna, check the receiver tuning, and test range from the driver’s seat before wrapping up.
Our FAAC Gate Access Control Process
- 1
You call, a person answers. Not a voicemail tree. We ask about the symptom and schedule a visit, often the same day for a gate that won’t open at all.
- 2
We diagnose on site. A uniformed, background-checked technician shows up in a stocked truck and starts at the control board, then works outward to the keypads, remotes, photo-eyes, and wiring. We test each component before recommending anything.
- 3
You get a price before we turn a bolt. We tell you what needs to be replaced, what it costs, and whether an OEM FAAC part or a quality aftermarket equivalent is the right call. No work starts until you approve the number.
- 4
We make the repair. On most FAAC access-control jobs, the repair is completed in that first visit. We program every remote and keypad, re-set travel limits, and confirm the safety reverse works properly.
- 5
We test it like we live there. The gate gets cycled repeatedly, the keypad gets typed on, the phone entry gets dialed. If a visitor can’t get in without you, we haven’t finished.
- 6
You get the 90-Day Done Right Promise. In writing. If it’s not right, we come back and make it right. No paperwork, no arguing.
What FAAC Gate Access Control Costs in Little Elm
FAAC access-control work in Little Elm falls into honest ranges, and we quote the job before we start.
- Keypad replacement or repair: $165 to $380 including the part and programming.
- Remote programming or replacement: $85 to $240 depending on the receiver and number of remotes.
- Control board replacement: $340 to $680 for a FAAC 412 or 415 board, programmed and tested.
- Photo-eye repair or replacement: $135 to $290 including wiring repair.
- Phone-entry or intercom integration: $220 to $520 depending on whether the existing unit can be reconfigured or needs a cellular gateway.
What moves the price: the age of the operator, whether the wiring has been spliced by someone before us, and whether the parts are OEM FAAC or a proven aftermarket equivalent. We’ll tell you which one makes sense and why. Call (432) 547-6481 for an exact quote, and remember the estimate is free. We don’t charge to show up and tell you the truth.
Why Little Elm Homeowners Call Ironworks Gate Co. for FAAC Work
We’ve been serving Little Elm and the surrounding areas for over 42 years, and we were founded in 1984 with the intention of being here for another forty. Victor Salinas grew up near the Little Elm Town Center back when the town was a fraction of its current size, and he runs Ironworks Gate Co. the way his father ran a welding shop: do the work right, charge a square price, and stand behind it. Our technicians are trained on FAAC as well as LiftMaster, Mighty Mule, Ghost Controls, and DoorKing, so we diagnose correctly the first time even when a homeowner has a mixed-brand setup. Every job is covered by the 90-Day Done Right Promise, and a live person answers the phone around the clock. We fix it right the first time, or we come back and fix it right.
FAQs
Yes. As an independent FAAC service provider, we service warranty and non-warranty FAAC gates in Little Elm. If your gate is under manufacturer warranty, we can diagnose the problem and advise you on whether the warranty will cover the part before any repair begins. Many Little Elm homeowners find it faster to have us complete the repair directly and pursue the warranty reimbursement themselves, but we will walk you through the options honestly.
In most cases, yes. We keep the schedule open for emergency gate failures, and a gate that won’t open at all is a priority. Call (432) 547-6481, tell us what the gate is doing, and we will give you an honest arrival window. Same-day service is available for many Little Elm calls.
Both, and we’ll tell you which makes sense for your gate. For control boards and receivers, we generally recommend OEM FAAC parts because the programming and safety logic are matched to the operator. For things like keypads, photo-eyes, and antennas, a quality aftermarket part often performs just as well at a lower cost. We never install a part we would not put on our own gate, and every part is covered under the same 90-Day Done Right Promise.
If the operator itself is still running and the gate structure is sound, repair is usually the right call. Access-control components like keypads, remotes, and receivers are designed to be replaced independently, and doing so costs a fraction of a full system replacement. When the operator is more than 15 years old or the board has failed twice, we’ll tell you straight whether replacement is the smarter money.
Yes. We install and service FAAC phone-entry units and video intercom systems across Little Elm, including systems that ring a house phone, a cell phone, or a mobile app. If your landline was replaced with VoIP or cellular service and your gate stopped ringing the house, that’s a common fix for us. Call (432) 547-6481 for a free estimate on integrating your FAAC gate with the phone system you use now.
Get Your FAAC Gate Working Again
If your FAAC gate access control is giving you trouble in Little Elm, call (432) 547-6481. A live person answers, 24 hours a day, 7 days a week. We’ll ask what the gate is doing, schedule a visit, and quote the repair before any work starts. Free estimates, upfront pricing, and the 90-Day Done Right Promise on every job.
Written by Victor Salinas, Owner, Ironworks Gate Co. at Ironworks Gate Co., serving Little Elm and nearby areas.